It is a type of Nut and Bolt
top of a mountain
a fulcrum is the part which balences it and the bar, put it on top of the fulcrum Force & Weight are the two parts needed to make a lever.
It is a class three lever. The fulcrum is the end point, the effort is in the middle, the place where you grip, and the load is the things you are sweeping away.
The stapler has its top and bottom joined at the hinge. Pressure applied on the top forces it against the bottom as the staple is pushed out. There is no mechanical advantage as with similar devices, such as the nutcracker.
This is the Class one lever
yes, the fulcrum is in between the input and output force.
There is a small lever by the door at the top of the back seat. Flip the lever and the seat should fold down.
A soda can consists of a cylinder, a top, a bottom, and a pop-top.
I once had a 1987 that had the same problem! On the inside of the tailgate, at the top ends, there should be a small lever. You can flip them one at a time and it will un latch the tailgate!
abra....
To flip the desk top you press control (ctrl) and alt (alt) and at the same time press one of the arrow keys.
soda can
Johny lever because he owns hindustan lever
There is a mechanical lever on top of the heater that you can reach if you remove the plastic covers under the dash, just flip it to the other side.
No a cylinder only has 2 faces, the top circle and the bottom circle. If you are confused look at a soda can, the top of the soda can and the bottom of the soda can are your 2 faces.
a tablet