Compressor oil ! ( light clear mineral oil)
Advice is to replace compressor the clutch goes bad only when the compressor goes bad on this model. They are sold to guys that rebuild compressors. Napa has the best price for clutches if you still want to try. Ebay there is a guy that sell rebuilt compressors for just a little more than the new clutch.
You will need to buy a replacement free-wheeling pulley that goes in place of the seized a/c compressor......
If it has multiple belts, remove the belt which goes to the compressor. If it has a serpentine belt, reroute the belt so it bypasses the compressor.
Common wire of the potential relay goes to the compressor contactor. (5) Start wire of the potential relay goes to compressor run capacitor. (2) Run wire of the potential relay goes to the start capacitor. (1)
There is a little button on the drill nearest the tip, where the bit goes, that must be depressed as you turn the very tip counter clockwise. This works whether the drill is plugged in or not.
The 2003 Pontiac Montana air conditioning compressor condensation drain begins on the bottom of the air conditioner compressor. The drain goes from the compressor to the bottom of the engine compartment.
Google Pontiac boneville ac compressor bypass pulley. There are a few places that sell a replacement pulley that goes in the spot of the compressor that allows use of the original serpentine belt.
the big line is the suction for the the compressor in the A/C unit, The small line is the compressor discharge that goes to the furnace
Its always best to drain the oil from the old compressor and then add that same amount back to the new compressor but to be on the safe side add 4 ounces and prime it on the bench first...
Sounds like the compressor is shot and it would be best to replace both. Unfortunately when the compressor goes bad it sends metal trash throughout the system. If you replace the compressor with out having the system flushed clean (which is almost impossible to do) the trash in the system will eventually destroy the new compressor.
The clutch bearing for an AC compressor is located in the center of the clutch. If the bearing goes bad, then the clutch is replaced as a whole part rather than changing the bearing.
She was a model for a bit for money but she goes the University. She isn't a model now