Left
under the center consul in front of the gear shifter
You need to replace an oil seal on the gearbox.
1) reduce throttle to idle speed 2) move gear shifter to Neutral position 3) move gear shifter to Reverse position.
if it has a S on it, it is like sport mode it keeps you in a lower gear
shifter rod gear linkage
To replace the gear shifter on your bike, follow these steps: Begin by removing the old gear shifter by loosening the bolt or screw that holds it in place. Slide off the old gear shifter and disconnect any cables attached to it. Install the new gear shifter by sliding it onto the handlebar and reattaching any cables. Tighten the bolt or screw to secure the new gear shifter in place. Test the new gear shifter to ensure it is functioning properly before riding your bike.
your shifter linkage is probably broken.
Just put the gear shifter into od and go.Just put the gear shifter into od and go.
This is to prevent the car from going into gear when it is not meant to. You must have the key in the on position before you can move the vehicle out of park.
The gear shifter has a retaining clip, just below the shifter knob. Hold the retaining clip in, on both sides of the shifter rod, and the shifter knob will come off.
the back up light switch is located in the gear shifter console