answersLogoWhite

0

Low octane. Either run better gas, or turn back the timiong a touch. (retard)

User Avatar

Wiki User

14y ago

What else can I help you with?

Continue Learning about Physics

Weight of 350 Chevy crankshaft?

The weight of a 350 Chevy crankshaft is typically around 50-60 pounds. This can vary slightly depending on the specific design and materials used.


How much does a 350 small block Chevy weight?

A 350 small block Chevy engine typically weighs around 500-575 pounds, including components like the intake manifold and exhaust manifolds.


How do you know if your Chevy 350 is internally or externally ballanced?

One way to determine if a Chevy 350 engine is internally or externally balanced is to check the harmonic balancer. If the balancer has counterweights welded to the outside, it is externally balanced. If it does not have any counterweights visible on the outside, it is internally balanced. It is always best to consult the engine's specifications or a reliable source to confirm the balancing type.


What is the measurement of a bore of sixety over on at Chevy 350?

A typical bore size for a Chevy 350 engine is 4.000 inches. A bore measurement of "sixty over" indicates that the bore has been increased by 0.060 inches, resulting in a final bore size of 4.060 inches. This modification is common in engine rebuilds to increase displacement and improve performance.


What is the torque for a fly wheel on a 73 Chevy 350?

The torque specification for a flywheel on a Chevy 350 engine is typically around 60-65 ft-lbs. It is important to consult the specific vehicle manual or contact a professional mechanic for accurate torque values and proper installation. Applying the correct torque is crucial to ensure the flywheel functions properly.

Related Questions

Does a 1979 Chevy small block 350 have a knock sensor?

no


Where is the anti knock sensor on a Chevy 350 block?

It is in front of the starter on my van.1990 350


What is the anti knock sensor on a Chevy 350 for?

It signals the computer to reduce the ignition timing.


How can you tell the difference between a Chevy 350?

BETWEEN a CHEVY 350 AND WHAT? Ask A question that makes sense !


How do you check a knock in the engine on a 1978 Chevy 350?

if its a loud knock from the bottom end, DO NOT run the engine, it is likely a spun bearing; have a professional look at it


Why does 1999 350 5.7 lt engine ping?

PROBABLY a faulty knock sensor, however, you'll need to run a computer diagnostic test to find out for certain.


Where can you put the knock sensor of a 1989 Chevy silverado 350 tbi when doing a Chevy s10 350 conversion because the motor mounts are in the way of its original spot?

In place of the coolant drain plug on either side of the block.


Why does 1970 Chevy 350 ping?

Could be too much compression for the fuel being used, or maybe the timing is too far advanced.


What would cause a knock on the bottom end of a 350 Chevy engine?

Sounds like a rod bearing. Time for a rebuild job.


What is the sensor directly above the oil pan gasket next to the starter in my Chevy 350?

What year, and application? NEW ANSWER: That would be the knock sensor,


What is the sensor above the 350 engine oil pan and starter on your 1990 Chevy c1500 truck?

oil pressure switch or knock sensor


Is there an adapter plate to mate a 1971 Pontiac 350 in place of the Chevy 350 in my 1994 silverado?

ati converters makes one