Want this question answered?
To bypass the ignition switch on a 1994 Chevy Astro, simply attach a wire to the ignition switch where it makes contact after the key is turned on. Run the wire to the push button and install at the lower part of the ignition switch to send power to the starter. Ê
The coolant capacity of a radiator in a 1986 Chevy Cavalier is 10.3 quarts. You can use any standard radiator fluid that's made for all makes and models of cars.
A Turbo Would Be Good For Starters..I Plan On Getting Mine When I Can Afford One ($2600).GarrettBB).www.streetfire.net Has 458Whp Cavalier!
Bad wheel bearing or there is a problem with the tire itself.
my first thought would be to check the starter . if you can tap on the starter and it starts after that..you have a bad starter .
when you turn your key and you only hear humming noise, the problem will most likely be that the starter is not engaging the fly wheel, its turning but is not sliding forward to do its job. have the starter check.
If you can't get it to start with a good battery and you can't see any bad wires, etc. - you need to remove it and take it to a parts store to be checked. (it probably makes sense to just replace it while it's off.) at $200.00 for the starter i would make real sure you need one also check all the starter relays, and your ign switch. ANSWER: Just buy a new starter!
Some possibilities, could still be the battery, battery connections, starter, starter connections, ignition switch, starter relay and neutral safety switch.
After thinking about this a bit it has to be on the starter, which is on the lower left side of the engine. I was trying to confuse this with the starter relay which Ford has long mounted up on the fender and makes things easy to locate starting problems.The solenoid is located inside the starter.
The brake light switch is either defective or out of adjustment if applicable.
reset what? this makes no sense. sorry .
Disconnect battery. remove to bolts holding starter, may have to remove tranny dust shield for room to move starter around to get it out will be wires on syl remove them if shims are used dont replace unless starter makes noise after replaced