0
What else can I help you with?
Where is the ignition module on an 1987 Crown Victoria?
the ignition module is on the distributer(the thing all the spark plugs wires go to)
How do you replace the Ignition Module in the Chevy Celebrity?
To replace the ignition module in your Celebrity: Unplug the wires, take note of where they go so you can put them back in the correct place. Remove the screws that hold the ignition module in place. If the old module was coated with dielectric grease on the mounting surface put fresh dielectric grease on the replacement ignition module. Put the new ignition module in place and attach with the screws. Plug the wires back in their respective places.
Where is the ignition module located on a 1989 Mazda b2200?
where is the ignition module located on a 1988 Mazda b2200
Where is the ignition module 1999 Laredo?
The engine computer is the ignition module.
Where is the ignition module on a 1996 stratus?
The engine computer is the ignition module.
Where is the ignition module 97 explorer?
Where is the ignition module 97 explorer
Where is the ignition control module on 1994 Ford Van E250 6 cylinder?
The only way I can explain it is to follow the wiring from your coil pack (where the spark plugs are) and the wires plug into the ignition module. Also go go www.wrenchead.ca and it has a manual that explains all. if you don't know the answer to a question please keep your moth shut ,please don't waste my time
How do i change the ignition module in a 1998 suburban?
Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.
Where is the ignition module on a 88 tracer?
ignition control module is under the distributor cap
Where is the ignition module on a 1995 Honda civic DX?
the ignition module is located in the distributor
Location of ignition module 1998 chrysler?
The engine computer is also the ignition module.
How do you replace ignition module in a 98' Malibu?
Remove the ignition module retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition module.
