There are dozens and dozens of malfunctions that will cause the check engine light to stay on. You need to have the codes checked to know possible causes.
The Jeep Laredo back light would malfunction would malfunction in much the same way any back light would, primarily due to cross-wire, or an internal error.
Umm. . . I would read the manual first ,but from experience the light might not turn off because of the gas cap not on right or tight enough something clogged in the motor or just on from last malfunction but might just be broken and on
The computer has detected a malfunction and set a code. Have it checked for codes with a scan tool.
You have a turn signal light-bulb out .
The airbag light stays on when the airbag computer detects a malfunction and sets a code. You need to have the system checked for codes to know possible causes.
Maybe, the check engine light comes on when the computer detects a malfunction and sets a code.Maybe, the check engine light comes on when the computer detects a malfunction and sets a code.
A malfunction has been detected
Defective oil sending unit, blown bulb.
I just had a warranty repair for an airbag indicator light malfunction on my 2005 Chrysler Town and Country. The service persons said it may be possible the airbag would not function properly in an accident if not corrected. They diagnosed the problem to be in a seatbelt sensor that is tied into the airbag system. The ordered part was installed on 9/19/08 and everything appears to be okay now.
The airbag light stays on when the computer detects a malfunction and sets a code.
Im having the same problem with my 2002 passat. It's probably a sensor or something. You probably should have a diagnostic test run on it, if you can. I dont think its terribly important, because in the manual it would say DO NOT DRIVE CAR.
The check engine light comes on when a malfunction with the emission control system has been detected - if the light stays on ( and doesn't correct itself ) have the Ranger scanned for trouble codes to diagnose and then repair the malfunction