tungsten
Magnesium and Titanium.
filament
should be in the fuse panel under the dash on the drivers side or in the glove box. if the light isn't working make sure you replace the bulb with the correct one, if you use a single filament bulb and its supposed to be a dual filament bulb your lights wont work properly.
The most likely cause is a bad brake light switch (if none of the brake lights illuminate) but if its only one of the brake lights, try changing the bulb. Even if they still work as running or turn lights because they have a double filament and may still work partially, but not as brake lights.
Thomas Edison faced challenges such as finding the right material for the filament that could withstand high temperatures without burning out quickly, creating a vacuum inside the bulb to prevent the filament from oxidizing, and designing an efficient electrical distribution system to make the light bulb practical for widespread use.
It may not be the fan making "more" noise when you turn on the lights. It may actually be the bulbs making noise. Incandescent bulbs when operating on a dimmer make a high pitched noise - it is the filament vibrating. Try just the lights without the fan and see if you hear anything.
Because a strong electrostatic attraction exist between halogens and metals.
A light bulb glows when an electric current passes through the filament inside, which heats up due to resistance and emits light. The filament is usually made of tungsten, a material that can withstand high temperatures without melting.
Yes, the resistance of the filament of a light bulb is what generates enough heat to make the filament glow and produce light.
Make sure both bulbs are good (dual filament bulbs) check the brake light switch on the brake pedal. Also, if you are wired for a trailer hitch, the 4-5 wire module may be bad. Eliminate it and check the brake lights again.
The anther and filament make up the stamen, which is the male reproductive structure of a flower. The anther is the part that produces and releases pollen, while the filament supports the anther.
No, copper wire cannot be used to make the filament of an electric bulb as copper wire has very low resistance. Therefore, the bulb will not glow if current is passed. It would also melt - the filament has to be white-hot to be any use!