Want this question answered?
High pressure.
Yes.
They Blow Clockwise
They Blow Clockwise
They will blow in opposite directions.
Until you blow one up in controlled testing, you won't know. SAMMI publishes maximum pressures for cartridges that should not be exceeded.
I'm having this same problem at home and I was told to hire a plumber who can blow out the water lines running from the pressure tank into my house.
If your expansion valve is sticking and not cooling try this first, bled the freon first open the lines that go to the evaporator, high and low pressure lines from the firewall, engine compartment. Take a low pressure air line and blow out any restrictions in the line back and forth on both lines. Once you have done this take some break free lubricate and spray in both lines and blow with low pressure back and forth to make sure the lubricant has reach the expansion valve and let
Yes, winds always blow from areas of high pressure to areas of low pressure.
You actually SHOULD replace the galvanized lines as they completely rust up on the inside. The only other thing that you could do is purge the lines with high pressure air or water. Careful though! You would be taking a risk that a fitting would blow!
High pressure.
Yes.
The pressure of the sun causes the wind to blow.
They Blow Clockwise
They Blow Clockwise
higher pressure to lower pressure
The set pressure is the pressure at which a relief valve starts to open. When the valve is open and relieving, the pressure will be higher or lower than the set pressure, depending on the system and the valve design. That is the blow-off pressure.