Want this question answered?
Do you mean your beads are concave and you would like them convex in appearance while autogenous welding is being done? Without knowing what metal you are welding or seeing the technique used I can only offer generalizations. It could be a lack of sufficient sulfur or improper travel speed. Without more info I'm only guessing.Which isn't good when it comes to welding.
It's when the different metals parts haven't melted together properly
used in aerospace and other high tech welds with lack of oxidation
Incomplete penetration (IP) or lack of penetration (LOP)occurs when the weld metal fails to penetrate the joint. It is one of the most objectionable weld discontinuities. Lack of penetration allows a natural stress riser from which a crack may propagate. The appearance on a radiograph is a dark area with well-defined, straight edges that follows the land or root face down the center of the weldment.Mechanical Design EngineerMoustafa I. Eldysouky Eldarandaly
Porosity is caused by molten puddle problems: oil, dirt, etc near weld, lack of shielding gas (tank is empty, or wind is blowing away gas. local vaccums for ventilation also can cause gas problems.) If mig welding, if you don't balance wire speed to amps, you may see porosity. Lastly, long arc'ing (too much distance from end of mig wire, to material) can cause bubbling.
It's when the different metals parts haven't melted together properly
Generally, what is meant by stupid is showing a lack of intelligence.
The main causes of accidents using welding equipment is lack of care during safety procedures. It is important when dealing with dangerous equipment to also follow the correct safety steps.
Felonies are acts or omissions penalized by law. It may be committed by means of deceit or fault. Those which are committed by fault are called culpable felonies. There is fault when the wrongful act results from imprudence, negligence, lack of foresight or lack of skill..
Scientists also look for areas where earthquakes have not occurred along an otherwise active fault.
Do you mean your beads are concave and you would like them convex in appearance while autogenous welding is being done? Without knowing what metal you are welding or seeing the technique used I can only offer generalizations. It could be a lack of sufficient sulfur or improper travel speed. Without more info I'm only guessing.Which isn't good when it comes to welding.
used in aerospace and other high tech welds with lack of oxidation
It's when the different metals parts haven't melted together properly
starving
The world is an unequal place not because of any one person\'s fault, but because of the lack of a collective conscience that sees everybody as equal. In short, it is everybody\'s fault that the world is an unequal place.
A lack of food, the ice covered the plants and froze them to death and blocked out sunlight, lack of plants led to lack of herbivores which ultimately meant the extinction of many species.
In the mid 1970s, Peter Lewinsohn argued that depression is caused by a combination of stressors in a person's environment and a lack of personal skills. More specifically, the environmental stressors cause a person to receive a low rate of positive reinforcement. Positive reinforcement occurs when people do something they find pleasurable and rewarding. According to learning theory, receiving positive reinforcement increases the chances that people will repeat the sorts of actions they have taken that led them to receive that reinforcement. In other words, people will tend to repeat those behaviors that get reinforced