If you don't allow the conductors to sag then, when they contract in cooler weather, they could (a) snap, (b) break their insulators, (c) pull poles over, or (d) pull intermediate poles out of the ground.
It depends on the equipment. The problems can be anything from a risk of electrical shock to semiconductor failure.
If the wire is carrying an electrical current, and if the current has enough voltage, the current can leave the wire and pass through your body. This is painful, and can causes burns or death.
For the circuit to get cold it must include a reversed junction thermocouple like in an electrical thermocooler.
You can, but it's not advisable to do it, unless you happen to be a certified electrician. Always call in a professional, it'll save you the money of having the professional fix your mistake.
You might think this is a good idea, but it isn't. The code requires a single cable of the required current carrying capacity. What would happen if one of the cables was damaged and the hot wire severed. Then the other would be carrying 40 amps and you wouldn't know it until your house burned to the ground. <<>> No, the electrical code states that no conductors of similar conductivity in sizes smaller that #1/0 copper shall be permitted in parallel.
It could fry the battery or the electrical system on the vehicles
You'll burn up the battery and may damage the electrical system.
it will bust
You can suphocate
dead
If the electrical system has been installed incorrectly or there is a MAJOR fault, then yes. Extremely unlikely to happen as there are many levels of redundancy and failsafes built in to modern showers. If you are concerned, get it checked by an electrician.
· What can happen if your hardware and computer cables are not maintenance?
You risk frying the electronics.
it will buse
Back up generators
The jig could be worn or damaged or it might not be clamped or secured tightly. It is also possible that the tool was not held tightly against it. It depends on the jig.
You will not be able to hold any memory