Get the motor mounts, trans mounts, transmission, radiator from a 1976 Malibu or Monte Carlo and swap them in.
yes.
The biggest motor made by Pontiac was the 455 cubic inch V8 engine. It was produced from 1970 to 1976 and was known for its performance and power output.
One way to do it is with an engine hoist. Loosen and remove the through bolts in the motor mounts. Carefully raise the engine with the hoist until you have enough clearance to unbolt and remove the engine mounts. You must be careful and work slowly when raising the eingine, though.
Any major auto parts chain store, like autozone, or napa will have them.
yes just have 302 motor mounts installed and proper drive shaft!
Probably along the frame rail driver's side--follow fuel lines
It is possible to replace the rear body mounts on a 1976 Corvette without completely removing the body, but it can be a challenging and time-consuming task. You may need to partially lift the body off the frame to access and replace the mounts. Having the right tools and equipment can make the job easier and safer.
Put a jack under the engine for stability. Unbolt one motor mount, and jack the engine up slightly. The mount should be able to be removed, replace it and repeat for the other side.
Yes both the 350 and 305 will fit,most firebirds came with 350 in the 1976 year as long as you have the correct mounts with a little work they will fit,try going to www.thirdgen.org and posting the swap in the forum alot of people will give you there info and alot have done it before
18436572..........counter clockwise. Driver side bank front to rear 1357 PS..2468
Polly Frame was born in 1976.