Want this question answered?
Filler/level plug is located at the front side of the gearbox
behind nsf wheel on end of gearbox end cover 19mmplug head
Side of the gearbox is a 17mm hex plug. That is the filler level plug. Easiest access is through the n/s wheel arch.
on the gearbox
The Filler plug is a hex head plug about half way up the gearbox on the passengers side. The head is about 15/16s or 1inch drive. This plug will be hard to get off and should be removed BEFORE cracking the drain plug to change the gearbox oil in your IS200. The filler plug is closer to the flywheel than you might think (closer to the front) and can be removed using a shifter (there is enough space around the head of the plug). The drain plug however is different. It's not the star head plug on the bottom of the transmission, (this contains a magnetic spring to catch debris), the drain plug is still on the side (passenger) of the gearbox and is the same size as the filler plug. This plug is surrounded by the design of the gearbox and you must use a socket to remove it.
its on the side of the transmission facing the front of the vehicle... the drainer is on the bottom and it is a 24mm bolt..
Hi Remove plastic covering where the gear change cable go. You'll see the oil level / filler plug on the gearbox casing. 8mm hex head to loosen. Have fun
Where the driveshaft enters the gear box. There are two plugs, the top one is the filler/level plug.
You Have to remove the gearbox oil sump than you will see a square oil filter.
There is a filler level plug, You'll need a 12mm allen key for that. It is located on the front face of the gearbox casing, next to the reverse light switch.
Comma MVMTF1L 75W-90 fully synthetic. Filler plug is behind plastic cover on the front of the box.
you phrrt on them