Plugs,Wires,Rotor Cap and button.Fuel filter,air filter
i have a Lexus coup sc300 year 1992 i need a engine and my intake manifolds are bad
sc300 Lexus is the same as Toyota Avalon or v6 sedan.open the hood locate your drive belts follow the lower radiator hose at the end right by the water pump inlet is the thermostat two10mmbolts need to come out .removed the alt-a/c belt for easy acces
A certified Lexus dealer in Columbus, goes above and beyond to implement our service and experience to assist your every need. Located in Columbus OH, Lexus of Easton is proud to provide new and used Lexus cars, parts, accessories and service to the drivers of Upper Arlington, Gahanna, Westerville, Bexley and beyond.
Fill up your tank with gas and mark down your mileage, drive until you need gas again and fill up. Mark down your mileage along with how many gallons you put in. Subtract the latest mileage from the first mileage you wrote down and then divide the gallons put in.
me too, they do not appear to have this or find the correct part at most auto parts stores, I am going to have to go to the dealership...
As the Lexus is Toyota's premium brand the parts to repair a Lexus will be more expensive than the same parts for a Camry. But the Lexus is one of the most reliable vehicles you can buy. At 90,000 miles the Lexus and Camry both have many miles left before they need any major repairs, assuming they were serviced regularly. Look closely at each car and see if it appears they were taken care of. I would pick the Lexus over the Camry although both are very dependable automobiles.
Lexus is the luxury version of Toyota, a Japanese company. They already have Toyota and no need for the badge of Lexus.
First you need to find a 1991 Lexus IS300...
92 Lexus is OBD 1. There is a plug for Lexus OBD 1, and will not work with an OBD2 scanner.
YES. Lexus recommends this changed at 90K miles
i need to know where the alternator is located on a 1990 Lexus LS400
All you need to do is push down the plastic cover at the bottom of the shifter, where the leather ends, it wont come out just push down and youll find two Phillips screws take them out and the shifter knob can then be pulled up there is nothing to disconect so don't worry. **just make sure that when your doing this its in NEUTRAL. (That's the secret!)