answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What pressure is needed to open a check valve?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does a piston check valve open because of pressure or flow under the piston?

NO IT WILL NOT OPEN.....


Dodge 318 1987 carb runs out of gas bowl is dry?

Check fuel pressure at pump? if you have pressure, check float NEEDLE WIRE that helps open the valve.


Difference between set pressure and blow-off pressure?

The set pressure is the pressure at which a relief valve starts to open. When the valve is open and relieving, the pressure will be higher or lower than the set pressure, depending on the system and the valve design. That is the blow-off pressure.


How do you check the tire pressure in your car?

You need to purchase a tire pressure gauge. Using this, remove the dust cap on the tire valve and press the socket of the gauge firmly onto the open end of the valve. The gauge will show the tire pressure in the tire. After using the gauge replace the dust cap on the valve.


Why low water pressure in your kitchen and no hot water in your front bathroom why?

Is the stop valve fully open? is the inline filter clean? check these first. check aerators too.


What is meant by air to open valve?

An air to open valve is a type of control valve that requires air pressure to be applied in order to open the valve. When the air pressure is removed, the valve will close automatically. This design is commonly used for safety-critical applications where a fail-safe operation is needed.


Why is water under pressure?

Find your main water shut off, make sure valve is open wide. check other exsisting shut off valves make sure they are open. With all valves properly open if pressure is still low, call the water supply company and have them check it at the curb.


Is water under pressure?

Find your main water shut off, make sure valve is open wide. check other exsisting shut off valves make sure they are open. With all valves properly open if pressure is still low, call the water supply company and have them check it at the curb.


Why would a propane tank vapor lock?

Because most modern tanks have a safety valve in them. If you open the valve too quickly, the valve will think that nothing is hoked to it and will shut off the output of the tank. Close the valve on the tank, dissconnect it from the regulator to let off the pressure and reset the check valve. Reconnect to the regulator and open the tank valve slowly..


Pressure switch adjustment?

This depends on what pressure control valve you have and the switch that comes with it. Some may be adjusted, others not, check for a small knob that you can check for pressure adjustment, best way to do this would be to open a tap (faucet) and then turn the adjustment knob down or up to the required pressure.


I have a doubt in safety air pressure relief valve that is how to evaluate the performance of the pressure relief valve?

Make enquiry's with the manufacturer of the compressor and get the max pressure rating. Then let the pressure in the tank build up to that level. If it does not open get a new valve


Does it put pressure on the pipe to turn off toilet valve and not the main water for 2 days?

It does not increase the pressure it remains the same as if the valve was open.