0
The ratio of RB1 to RBBO is the intrinsic standoff ratio. It is the standoff voltage ratio to the power supply voltage.
Wiki User
∙ 9y ago
Wiki User
∙ 11y ago.47to .8
Add your answer:
Earn +20 pts
What is standoff ratio in UJT?
the amount of potential to forward bias it
What determines the amount of potential required to forward bias a unijunction transistor?
Intrinsic Stand-off Ratio
How is a ratio used to describe change?
It represents an association between two values numerically.
Y California bearing ratio is called bearing ratio?
The ratio is a measure of the load causing penetration of some standard value say 2.5 mm or say 5.00 mm. This in turn is a meaure of the bearing capacity of a given soil subgrade within the limits of predecided penetration values. This precisely means it measures the bearing capacity of a given soil sample with respect to some standard known value soil / aggregate sample. Thus it is defined in the form of ratios of loads causing penetration of defined range wrt the known standard value. hence called a bearing ratio.
What is wide dynamic range in digital communication system?
ratio of the strongest transmittable signal to weakest discernible signal
Calculate the intrinsic standoff ratio eta H of a UJT circuit where Rb1 is 1500 ohms and Rb2 is 265 ohms?
5.6 isn't the stand off ratio calcutaled by ===== Rb1/(Rb1+Rb2)
What is standoff ratio in UJT?
the amount of potential to forward bias it
What is Intrinsic Impedance?
intrinsic impedance is ratio of E/H from a uniform plane ve in a materal
What is the intrinsic stand off ratio of UJT?
the amount of potential to forward bias it
What does intrinsic stand off ratio of an ujt determine?
The amount of potential to forward bias it
Is a ratio a comparison between two ratios?
A ratio is a comparison between two values. The values can be integers or fractions (ratios).
What determines the amount of potential required to forward bias a unijunction transistor?
Intrinsic Stand-off Ratio
How is the average for the set of values calculated?
The average is the ratio between the sum of these values and the number of values.
What is band ratio in remote sensing?
THE RATIO OF DigitalNumber VALUES OF CORRESPONDING PIXELS IN HYPERSPECTRAL REMOTE SENSING IS CALLED BAND RATIO
Is numerical ratio of average velocity and average speed is always less than one?
No - the ratio can be exactly one if the velocity vector is always in the positive direction, i.e. motion is only in one direction and that is the direction designated as positive. If you designate the ratio by the symbol "r" the range of possible values is: -1 ≤ r ≤ 1
When you make a solution of salt and water over what range of values can you vary the mass ratio of salt to water at a given temperature?
IPS Chapter 6 Problem 36. Do your homework yourself kid.
In the given ratio b and c are extreme values?
false
