i think it is symbolised with a capital 'e' or 'v' :P hope this helped! :L:L
"I" represents the current which is the flow of electric charge. Impedance is the measure of the opposition to the flow of current at a given voltage usually in a.c. circuits.
Computers are built off of electronic circuits, in which there is either no voltage or there is some positive number (usually 3.3V, 5V or 12V). 1 represents an electric charge while 0 represents no charge.
The time constant is precisely the product R times C. The result of this product will be a time; it represents the time for the capacitor to discharge to about 37% (1/e, to be precise) of its initial voltage.
I assume a series of amplifiers with one F/B The F/B is the portion of voltage/current F/B from input to output no matter how many amplifiers are in series within the loop or what the gain of each one is.
Regulation of transformer means percentage reduction of transformer secondary voltage due to transformer loading as compared to its no load voltage.Another AnswerA transformer's voltage regulation is defined as 'the change in its secondary voltage, from no-load to full-load, at a specified power factor, expressed as a percentage of its full-load voltage, with the primary supply voltage held constant'.
In electricity, P represents power, V represents voltage, and I represents current. Electric power = Voltage * Current. (P = VI)
1
VAC is voltage of alternating current signalDC current is amperage of a direct current signalAnswerYour question contradicts itself, as the symbol, V,represents voltage, not current.However, V a.c., represents an alternating voltage -one in which the direction in which the voltage is acting continuously reverses itself. Vd.c. represents a direct voltage, in which the voltage continuously acts in the same direction.
Step voltage is a type of AC voltage where the voltage signal represents a flat step up and then a flat step down.
True
The variable that represents potential difference is V, which stands for voltage.
1
Black.
The power of a battery is typically measured in voltage (V) and current (A). The voltage represents the electrical potential difference between the positive and negative terminals, while the current represents the rate of flow of electricity. The power output of a battery is the product of voltage and current (P = V x I).
i think it is symbolised with a capital 'e' or 'v' :P hope this helped! :L:L
It depends. If voltage is drawn along the horizontal axis, then the slope at any point on the graph represents the reciprocal of resistance at that point. If current is drawn along the horizontal axis, then the slope at any point on the graph represents the resistance at that point.
One A2:In positive logic (most logics), a High, that is, a positive voltage over about 3.5 volts, is considered a "one".