An odd stud pattern on the s3 1984 rx7 . It's 114.3x4...
4x110 or if its a GSL SE then its 4x114
Depends, which engine is in the 85, 13b or 12a?
yes, however you may need to adjust the wire harness to fit.
As long as its the FC3S model it will fit.
Inside the fuel tank
It depends on how many lugs there are. If they areboth 5 lug than it will fit. If the 87 is 4 lug then you would have to change the hubs to 5 lug.
Yes. If you have an RX7, then it already has a rotary...and if it is a 1997 then you have a rare Japanese model.
Gsl= 12A , Gsl-se 13B.
mazda doesnt rx7 anymore :(
The Mazda Rx7 has the Wankel Rotary Engine in it
Well yes and no. You can put them on your rx7, but the spring rate and stiffness may be too much or too little for your rx7 and it will need to fit the specific shocks/struts of your rx7.. The springs may have to be cut also depending on the clearance needed, give it a shot, and install it and see how it clears. if it clears, test drivie it in a safe area.
Mazda didn't make the RX7 in 1974.