Want this question answered?
The least amount of current will flow through the branch of a parallel circuit that has the most resistance.
lest resistance.....by aeroboy
Traditionally, a conductor has the least resistance of the three, followed by the semiconductor and finally the resistor.
The ThrustSSC
a blowgun is a big tube, like a straw. When you place a dart (or other object) into it, and blow in the end, you're increasing the pressure behind the dart, which propels it out the other end where pressure is lower. Objects always move toward the area of least resistance, and the pressure you create behind the dart creates a lot of resistance.
The higher the resistance, the less current will flow through it (while the supply voltage remains constant).
Yes, the resistance is directly proportional to length of wire and inversely proportional Area, hence when Length of wire increases the resistance also increases and when Area increases the resistance decreases. This means a thick wire has least amount of Electrical resistance.
Natural gas
The least amount of current will flow through the branch of a parallel circuit that has the most resistance.
Amount of resistance
lest resistance.....by aeroboy
The branch with the highest resistance in a parallel circuit will have the least current flow. Ohm's Law: Current = Voltage divided by Resistance
Traditionally, a conductor has the least resistance of the three, followed by the semiconductor and finally the resistor.
There are several substances that have zero electrical resistance. Those are known by the generic name of "superconductors". So far, superconduction has only been observed at cryogenic (i.e., "supercold") temperatures.
Depending on location, clearing vegetation can have numerous effects on flooding such as speeding up the errosion process which in turn creates a path of least resistance for water flow.
That's called path of least resistance.
Current goes path of least resistance. But if u have two resistances in paralell only the majority will go through the smaller resistance some Porportional Amount will "flow" through the larger resistor. Depends on resistance sizes and voltage slap plied as to how much current