Want this question answered?
The fan motor is bad. The fan motor capacitor may also be the problem. First, an amperage test should be done on the motor to see if its exceeding the rated amps. Secondly, the capacitor should be tested for the amount of microfarads it has. If its an old mtor, it should be replaced, along with the capacitor. All of this should be done by a licensed A/C contractor!
That would be done by a resistor connected between the two plates.
can,t be done with a capacitor alone current only flows when a capacitor is charaging or discharging. capacitors are used in motors for diffrent reasons some are cap start or cap run, or for power factor corection. you should make sure any capacitor is replaced with the correct voltage and amp rating.
It should.... I have done it before
Locate the defective capacitor, short the terminals to ground to release any stored energy and prevent shock, remove the old capacitor then install the new capacitor wired as the old one was and secure it in the bracket that held the old one - done.
Act happy and like you've done it before
Stretching
They should be checked for recording errors before any other work is done on them.
The cylinder should be evacuated
you should first ask yourself if you have done enough research on the candidates before you vote.
Backups!
He said they should have lit the fire on the beach.