Want this question answered?
dont touch it :)
YOU cant do it!! :)
(the metric unit) The average bacteria is only about a micrometer in length, so there may be thousands in a single drop of water. (the tool) He used a micrometer to measure the thickness of the circuit board.
it should be clean and dry there should be no error the thimble shouldnt be too tight
yes,probably we will get accurate measurement.
"What is the advantages of using micrometer?
When the jaws should be measured in micrometers is used in its place.
To avoid lifting of the bridge of the depth micrometer, make sure that the spindle is correctly positioned before taking a reading. The spindle should be parallel to the base of the depth micrometer and should be positioned directly over the object being measured. Make sure that the object being measured is firmly supported and that the work surface is free of debris that may interfere with the depth micrometer’s operation. Before taking a reading, check that the anvil and spindle are perfectly aligned with each other. Avoid pressing down on the depth micrometer too hard as this can cause the bridge to lift. Always use the correct size micrometer for the job and the correct size anvil for the object being measured. If the bridge does start to lift, stop and correct the problem before taking any further readings. Before taking a reading, always make sure that the depth micrometer is properly zeroed. When using a depth micrometer, always keep your hand away from the spindle and anvil. Make sure that the depth micrometer is properly maintained and stored in a dry, clean environment. Lastly, always use the depth micrometer with care and caution to avoid any damage or inaccuracy.
dont touch it :)
YOU cant do it!! :)
inspect it
A micrometer screw gauge is commonly known as a micrometer. This is a form of calipers used for measuring small dimensions. Screw gauge in extensively used in the engineering field for obtaining precision measurements. The article describes the principle and main parts of a basic micrometer screw gauge.
(the metric unit) The average bacteria is only about a micrometer in length, so there may be thousands in a single drop of water. (the tool) He used a micrometer to measure the thickness of the circuit board.
The least count of the micrometer screw can be calculated using the formula given below: Least count = 0.01 mm
By using a micrometer
it should be clean and dry there should be no error the thimble shouldnt be too tight
The easiest way is probably using a caliper micrometer.