0
What else can I help you with?
Can a 3.5 ton air handler match with a 3 ton condenser?
Yes it should be fine. It wont be as efficient as it should be. But it should remove more humidity from the air.
Can you install a 3.5 ton condenser on a 3 ton evaporator?
Installing a 3 1/2 ton condenser on a 3 tr evaporator will not function properly. There isn't enough evaporator coil surface area to absorb heat and vaporize refrigerant liquid for its return back to the condenser compressor. What can be done is a 3 ton condenser unit with a 3 1/2 evaporator coil.
When changing phase rotation of a 3 phase motor is this done at the switchboard?
The phase rotation of motor should be always done from motor side i.e The motor terminal box.
What 3 phase conction of eletical diagram?
what is 3 phase eletical conction digram of 3 phase motor
How do you calculate 3 phase earth fault loop?
You can't have a three phase earth fault, you can have a phase to phase or a phase to earth fault. If you want the potential phase to earth fault current it will be your voltage times your impedance. If you want the phase to phase potential fault current then you should just double the above result.
Why 3 phase and single phase?
3 Phase system is for industrial use and 1 phase is for house hold application
How do you convert a 3-phase system to a single phase?
By having a transformer with 3 phase input and single phase out put
Can you use 3 phase circuit as 3 separate single phase circuit?
Yes, a 3-phase circuit can be used as three separate single-phase circuits by connecting each load to one of the phase conductors. This allows you to operate three independent single-phase loads using the same 3-phase power source. However, caution should be taken to ensure that the loads are balanced among the phases to avoid overloading any of the phases.
How do you derive three phase single way?
3 phase /sqrt(3) * 30 degree phase shift = single phase.
How do you connected 3 phase motor to single phase power?
Use VFD to make 3 phase from single phase source.
How do I check to make sure a three phase transformer is still in working condition?
Using a properly rated voltmeter and following all safety precautions, check from phase to phase on each phase on the secondary side. phase 1-2 then 2-3 then 1-3 and they should all be within a few volts of each other.
What is the result when a 400v device's load is connected between the two phase legs of a 3 phase distribution?
It works normally. Well actually there are 380 volts across two lines of a 3 phase AC source, so it should work normally.
