answersLogoWhite

0


Best Answer

190

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What should be the running temperature of a jeep Sahara 6 cylinder?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What should the running temperature in summer heat be for a 4 cylinder 1993 cavalier at seventy miles per hour?

The temperature should be 195 degrees.


What is the correct running temperature for a 2002 Jeep Wrangler 6 cylinder?

210 deg F, it should be directly verical on the engine temp gauge.


When checking for non condensables inside a recovery cylinder why should the technician allow the temperature of the cylinder to stabilize to room temperature before taking a pressurereading?

butts


What is the normal running temperature on a 1997 Buick Riviera?

Your car's operating temperature should be 192 degrees.


Why should you not live in the Sahara?

they do


What is a safe room temperature for running a PC?

The ideal temperature of your room should be between 68-71o F You should not go below 50o or above 82o F.


What should be the correct temperature of running water which is used for thawing?

It depends upon what you are using it for. I generally use room temperature water for cooking.


What should the cylinder compression be on a good running 1996 dodge ram 1500 5.9l v8?

120-150 psi


Vauxhall corsa temperature went up to 100is this normal?

No it isnt. You should check your fan and oil. Running temperature is around 85-90


Does the Gallien Krueger 700 rb II series bass amp fan turn on at a certain temperature or should it be running constantly?

at certain temperature


What should the high low pressure for the AC be when running?

Depends on the ambient temperature - need a chart for details


How do you remove key cylinder on a 1997 Lincoln mark viii?

There are two (2) torque screws that hold the cylinder itself onto the car. Remove both and the cylinder should fall out. (this is the hard way) Remove one (1) Torque screw, bottom. Then turn the key to the ON position (not running) and then press the tab that holds the cylinder in and the cylinder itself should fall out. (this is the easy way)