0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Does the middle bulb on the tail light work?
If there is a bulb, it should work.
What light bulb replaces the existing bulb in a 1997 suburban?
Check the side of the bulb should be labeled or bring to auto parts store they should be able to identify
How do you replace rear turn signal bulb in 1998 Sunfire?
That bulb should be accessable from inside the trunk. Pull the carpet away from the area behind the bulb. There should be a screw out bulb holder. Just twist it and pull it and the bulb out. Replace the bulb and twist the bulb holder back into place. Re-seat the carpet.
How do you change the tail light bulb on a 1981 Olds Cutlass?
There should be some carpet or other material covering the bulb in the trunk move this out of the way then u should be able to access the bulb holder it should be about a quarter turn to get it out then the bulb should be a short counter clockwise turn while pushing in at the same time to remove the bulb, installation is the reverse of what you did.
Where can you find a cross reference for light bulb R136239?
Ge894 should be the bulb
Why you should not hold the thermometer by its bulb?
the bulb can feel heat, so holding it by the bulb can raise your temp. hope i helped! :)
How often should you replace a headlight bulb?
Replace headlight bulb only when blown.
When a toy flashlight does not work which two parts should you check and how are the parts related?
You should check the battery and the bulb. The battery powers the bulb.
What happens to the brightness of the bulb when the second bulb is put into a series circuit?
it should become dimmer
Can you replace a 60-55w headlamp bulb with 100w bulb without wiring changes?
You Should not. Danger of overheating bulb and wire melting
How do you change license plate bulb on a citroen c3?
Take out the plastic lens cover over the bulb. You will need a small screw driver to push and it should pop out. Replace the bulb (Bulb: W 5 W). Replace the lens which should click in place.
What will happen after you make an Electric Circuit?
If you connect the circuit properly the bulb should light up. That means attaching the left side of the battery to the right side of the bulb using a wire and attaching the right side of the battery to the left side of the bulb. If you do that the your bulb should turn on. If it doesn't then try changing the battery or the bulb.
