answersLogoWhite

0

I did the job myself a while ago and the parts only ran about $130 per side and $10 for the transmission seal. Took about 3 - 4 hours.

Don't forget to have them replace the seal.

RAF4

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you fix a speedometer on a 1995 mercury villager van?

It is not repairable, you should replace the instrument cluster.


Can a 1998 mercury villager transmition pan fit on a 2000 mercury villager?

It should be the same.


What should it cost to replace the fuel pump on a 1998 Mercury Villager?

Got the same issue, gas cutting off on hills. Does anyone have some good instructions on how to replace the fuel pump on a 1998 Mercury Villager 3.0 L? Thanks... HJC


Should one purchase a 1998 mercury Villager if speed sensor is needed?

The speed sensor is not expensive and is easy to replace.


Does 1996 mercury villager transmission fit in the 1995 villager?

Yes, it should fit.


When should you change the timing belt on a 2008 mercury mariner?

when should i change the timing belt on a mercury villager


When should I replace the timing belt on a 2000 Mercury Villager?

On a 2000 Mercury Villager : The recommended timing belt replacement interval is ( 105,000 miles ) The Gates website ( they make timing belts etcetera ) shows it as an INTERFERENCE ENGINE , so if the timing belt breaks engine damage will occur


Where is the thermostat in a 2000 mercury villager?

The thermostat at the engine in a 2000 Mercury Villager is located Êon the right passenger side near the middle. You should look for the jiggle valve on the thermostat that should be facing up.


Where is the thermostat located in a 2000 Mercury Villager?

The thermostat at the engine in a 2000 Mercury Villager is located Êon the right passenger side near the middle. You should look for the jiggle valve on the thermostat that should be facing up.


How do you replace the radiator on 1995 mercury villager?

Simply drain the system, disconnect the hoses and lines, unbolt the fan (2 screws), remove the retainers at the top, and it should come right out.


How do you replace front disc brakes of a 1996 Mercury Villager?

It would be to your advantage to take your car to a Brake Repair Shop if you have to ask that question brakes are not something you should do if you do not have the skill, WBMS


How do you bleed air from the cooling system of a 1999 Mercury Villager?

This should not be necessary on this vehicle.