.002 of an inch
The volume occupied by the cylinder when the piston is at top dead centre is called clearence valume.
As the piston moves up and down in the cylinder it also moves the piston rings up and down in the grooves. With the rings moving up and down it gradually increases the side clearence. Material is taken off from both the piston groove and the ring.
No fit.BECAUSE No contact between piston and cylinder.
The piston is prevented from tipping in the cylinder by the piston rings, which provide stability and guidance as the piston moves up and down within the cylinder. Additionally, the piston skirt design and cylinder wall clearance also help to maintain proper alignment of the piston during operation.
The "cylinder jug" is the cylinder. This is the area that the piston and piston rings moves up and down in when the engine is turning.
A cylinder is the central working part of a reciprocating engine, the space in which a piston travels.
a far from my knowledge one piston stroke is the distance the piston head traveled from bottom end of cylinder to top end of the cylinder
The general term for piston is cylinder, and a cylinder might be made to work in this application. But a cylinder used in this manner, that is, a cylindrical shape connected in a machine that is used in the same way will almost certainly be called a piston by most investigators.
The piston rings create a seal between the piston and the cylinder wall.
No, you dont need to remove the cylinder ridge before. I never have and i replace them all the time.
to remove the piston, you need to remove the carb and intake. You will then remove the 4 acorn nuts from the top of the cylinder head and the 2 bolts on the left side of the head. You can then remove the cylinder head and slide the cylinder up off of the 4 studs while insuring the piston is sliding out the bottom of the cylinder. Also take care in making sure the piston and connecting rod do drop against the studs as it exits the cylinder. To replace the piston, simply remove the cir-clip from either end of the recessed area in either side of the piston and you should be able to push the wrist pin from the connescting rod and piston. It is recommended that you replacee the cir-clip with a new one upon reassembly. And of course, you should reassemble with new head and cylinder-to-block gaskets.
a piston