Around 750 rpm with warm engine and in gear.
Around 750 rpm with warm engine and in gear.
Around 750 rpm with warm engine and in gear.
As far as I've been told, the idle is set by the pump? So if it's low the pump might need rebuilding soon.
Idle is computer controlled, there is no adjustment screw.
There is no idle sensor. Idle speed is computer controlled and is not adjustable.
Minimum of about 10 psi at idle, 30 psi at 3000 rpm
The idle on a 2001 24 valve is computer controlled and is not adjustable.
Idle speeds can vary from 500 to 1200 rpm
Your truck may have the idle to low or the compressor might have some problems
If it is and automatic transmission the idle will be at about 900 RPM and is not recommended to be adjusted but can be adjusted at the trottle position sensor (TPS) located just abouve the air heater intake on the driver side. If the truck is a manual transmission the idle should be in between 700 and 850 RPM and is not recommended to be adjusted but again can be at the TPS.
z idle adjustmentTurn the idle screw - on the intake manifold - clockwise to decrease rpm or counterclockwise to increase idle. You should also look around for a vacuum leak
500-1200 The computer will decide.
The fluid level in an automatic transmission in a 1995 Dodge Truck should be checked at idle in Neutral with the engine at operating temperature.The fluid level in an automatic transmission in a 1995 Dodge Truck should be checked at idle in Neutral with the engine at operating temperature.
Have the Cummins computer checked for trouble codes.