0
There should be information regarding the timing degree on a decal locaded under the hood.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you set timing on a 92 Toyota 4-runner 3.0?
What should the timing be on a 92 Toyota 3.0
Timing on a 89 dodge truck?
The timing on a 1989 Dodge truck should be set to 10* after unplugging the temperature sensor.
How do you set the timing for a 1992 GMC truck?
The computer should set the timing automatically by the sensors. If you change it, it must be done with a handheld computer.
If you installed a chip on your truck will it affect your timing when you adjust it?
timing should be set with chip disabled(curb idle)
Do you have to unplug anything be for you set the timing on 1987 Toyota 4x4 truck?
Yes the vacuum line off the distributor and don't forget to plug the hose.
How do you set the timing on a 1993 Toyota Corolla?
How do you disconnect the Data Port when setting the timing on a 1993 Toyota Corolla?
How do you set timing 1985 GMC 350 engine?
how do you set timing on a 1985 350 gmc truck
How do you set the timing on a 1996 a Toyota Corolla 1.4 ltr 4-cylinder?
There should timing marks, or you can consult a repair manual (very cheap.)
How do you set the timing on a Toyota Tazz?
you twist the buttons
How to set timing on 1996 Toyota Tercel?
you cannot adjust the ignition timing on this car. a manual will help if you need to set cam timing
How do you set timing on a Toyota 22R engine?
To set the timing on a Toyota 22R engine find the distributor. The engine will have marks at which the distributor can be set. The OEM setting for a 22R engine is 5 degrees.
What is the timing set to on a 94 Chevy 350 in a truck?
8 degrees btc Timing should be at 0 degrees ATDC that is factory XXXXXXXXXXXXXXXXXXX You need to set the base timing on any car/truck that has a distributor. There is a tan/black wire that is usually under the dash down low on the passenger's side. This is the Electronic spark timing and the connector has to be apart to set the timing. That will put the computer offline while you set the timing to the specifications. There is usually a decal under the hood. Once the timing is set then reconnect the connector The base timing is set NOW the computer will take over from there
