0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How long should laser printer fuser last?
How long does a fuser unit last in the copier, if you have a large number of copies to be run
When was Diego Fuser born?
Diego Fuser was born on 1968-11-11.
Do bubble jet printers use a fuser assembly?
no. There is no fuser in a Bubble Jet Printer.
What is fuser oil?
Dimethyoxysiloxane
What is the signs that a printer fuser is going bad?
To check for a faulty fuser assembly do the following. Open the clam shell cover of the printer. In the back of the printer is the fuser assembly unit. The green part of this unit on the back portion of the fuser will open.Remember the fuser runs at an extremely high temperature. Be sure you are touching felted portions of the unit only to avoid burns. Gently push the green rear portion of the fuser unit back. Turn the printer around and look through the back. Are there visible streaks or rips in the upper fuser roller? Are there any visible bubbles in the upper fixing roller?If any of these symptoms are present you will need to replace the fuser unit of the printer.
Where can you find information about 'Fuser'?
Fuser is a Unix command and requires some technical knowledge to fully understand. Information on Fuser is available from Wikipedia, The Geek Stuff or may be found in specialist magazines relating to Unix.
Which two parts in dot matrix and laser printer should be allowed to cool before repair?
#fuser assembly #print head
How do you fix a fuser in a printer?
Your best bet is to replace the whole fuser assembly. Many manufactures now design their systems with customer performed maintenance in mind. They offer CSR (customer replacable units) for many of their products. The fuser is usually one of the items offered. If your fuser falls into this catagory, see the manufactures representive in your area and order one. Installation is usually a snap out, snap in affair. Oh and yeah....it wont be cheap! If you are stuck with the older fuser assy and the roll can be replaced by itself. This job should be left to the manufactures tech. The possibility of damaging other parts while trying to remove the fuser heat roll is great (and costly). It would be a crying shame to have the roll almost in and then put a big scratch in the coating. Every copy would show the result of your screw up and no the warrenty does not cover it. I don't know the cost of a fuser roll now, but they were spendy a few years ago. The hard part is going to be finding the fuser assy and parts. Try the manufactures web site. If you have no luck there, check with a dealer in your area and see if he would be willing to sell you a fuser assy. Either route will be costly. Les On the older printers, most fuser assemblies cost more than a new printer unless it is a high end model.
How do you fix a 13.20 error on a hp laserjet 9000 printer?
There is a problem with the fuser that has damaged the DC controller. You will need to replace the DC controller and fuser at the same time.
Do you have to replace coil when you change a spark plug?
Only if it's bad. Be careful when removing..
Where is the fuel pump on a 1990 Mazda 323?
the fuel pump is in the gas tank, you can get at it by removing the rear seat and you will see it right there. be careful while removing it.
How do you rock a card to remove it from its slot?
I would be very careful with it as if your not careful you can damage it.Start by removing the hinges from the side and try "Rocking" it from the ends not the sides.
