0
What should you do before cleaning the top of a storage battery and rinsing it with fresh water?
Wiki User
∙ 13y ago
the answer is A : tighten the caps and plug the vents
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What does 8-hours of battery mean?
It means the battery will operate a device for 8 hours before recharging is needed.
Will you lose your data if you remove the battery?
On a laptop computer? Not if the data has been saved and the computer has been properly switched off before the battery is removed.
What chores did pioneer children do?
Pioneer children helped with many chores, many before dawn. The chores they did include feeding the cows and chickens, gathering up eggs, cleaning out animal pens, cooking, cleaning the house, and doing laundry.
What kind of battery is in an electronic cigarette?
There are multiple battery sizes for electronic cigarettes. The batteries are measured in milliamps hour (mAh). Most batteries come in sizes 650 mAh, 900 mAh, 950 mAh, 1000-1200 mAh. The higher the mAh, the longer the battery will last after being fully charged. Therefore, if you have a larger mAh battery, you will be able to get a greater puff amount before having to recharge the battery.
How do you make my itouches battery last longer?
to save your battery go to settings then turn down the light put dot into the middle you will adjust to it it does make a difference also plug it in whilie you sleep and try not to use internet thet much thanks for reading commet.
Which component should be removed before cleaning a laptop?
battery
What is the best product for cleaning upholstery?
It's not much about the product as no generic cleaning agent can remove all types of marks and stains. For fabric upholstered furniture, steam cleaning is the best and most effective cleaning process. That is essential as fabric needs rinsing. But before steam cleaning, you should vacuum first. Consult a professional cleaner or your lounge manufacturer for recommendations.
What uses chemical reactions to create an electrical current?
A storage battery falls into that category. A load has to be applied to the battery before an electrical current will flow.
Is it okay to wash your navel piercing with soap water and just move it around in the bath?
Rinsing the piercing with running water is the best be so do that before you get out of the bath, but cleaning with soap and water is just fine. Be sure you rinse the piercing with clean running water before you get out.
How long is to long to leave jewelry in jewelry cleaner?
Chemical cleaners are fairly caustic so it is best to only apply to jewelry for 1-2 minutes before rinsing and wiping. Also, note that non-metal components in jewelry such as stones or glass can sometimes be damaged by cleaning agents. Research specific stones before choosing a cleaning method.
Is it bad for a vehicle not to be driven for three weeks?
Three weeks is no biggie. If it makes you feel better disconect the battery before storage and check the tire pressure and oil level in addition to leaks under the vehicle before driving again. Longer storage will require you to empty the fuel tank and change the oil right before storage.
Clean The Battery Before Charging?
Before you charge a car battery, it is a good idea to clean off the connectors. If these are dirty or corroded, you will not get a good connection. This can make it take much longer for the battery to get a full charge. Cleaning it will only take a few seconds. You should do this each and every time that you have to hook it up to the battery charger at your house.
How do you change the battery in a 1977 Corvette?
The battery on a 1977 Corvette is located behind the drivers seat, in the storage compartment farthest to the left of the vehicle. To remove the battery, open the storage compartment door. Remove the negative cable first before anything else so there is no danger of grounding out the positive terminal. The negative terminal is always black, and has a - (minus) sign on the battery. Next , remove the positive cable from the battery . Finally, remove the battery hold down . This is usually a long bolt and metal plate, or it may be a strap , and the battery should lift straight out of the storage compartment. Be careful not to tip the battery over, or make contact between the battery terminals. Installing the new battery is the reverse process. Make sure to install the positive cable before the negative . This helps to prevent grounding out the positive cable .
Why won't my Nissan 2011 rogue start I put the headlights on but they are dim and I just replaced one of the batteries I had to jump it before the battery replacement?
Either:-Your new battery is badYour new battery has not been fully charged before installationYour battery terminal clamps are not tightYour battery terminals/clamps are corroded and may need cleaning/replacementYour battery cables are faultyIf all of the above is not the case then you have an electrical problem.
I'm on a tight schedule in the mornings. How long must this hair conditioner be left in before rinsing?
The conditioner only has to be left in for a couple minutes before rinsing out, which makes it ideal for your situation. Other conditioners need longer to sit.
Why does your engine click when trying to start on your 1999 Saturn?
That's usually a low battery or a dirty battery terminal. Check the terminal first, see if it's corroded or loose. Next, understand that the battery is simply an electrical storage device. The battery can be bad or the alternator can fail and the battery will not have enough stored electrical energy. Before just replacing a battery, always check the charging system to make sure it's working properly before assuming that a battery has failed.
How do you maintain a laptop battery?
When people buy a laptop, battery life and maintenance has become the important part. Then how to maintain the battery? Your new laptop battery comes in a discharged condition and must be charged before use (refer to your computer manual for charging instructions). Upon initial use (or after a prolonged storage period) the battery may require two to three charge/discharge cycles before achieving maximum capacity.
