According to the 1996 Ford F-250 owners manual it came from the factory with
either the Motorcraft BXT-65-650 battery or the optional BXT-65-850 battery
( that's BCI group size 65 and either 650 or 850 cold cranking amps )
that's for the 5.8 liter / 351 cubic inch V8 engine , I would go with the 850
No. To erase codes form an OBD-1 vehicle (made before 1996), the engine does not need to be running.On a side note, NEVER disconnect the battery while the engine is running; it will damage the computer.
clicking when trying to start is usually caused by flat battery check charge in battery if not battery ,you need to eplace starter mptor
The fuse location for the head lights on a 1996 Nissan is in the engine compartment. You will need to open the hood and look between the battery and the driver side.
Depends on the engine and the work load being placed on the truck.
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
im pretty sure its 3
Diesel engines need more cranking power than what one battery provides.Diesel engines need more cranking power than what one battery provides.
your oil could be too thick to allow the engine to crank over fast enough to start, or you might need a new battery!
1st need to know what engine you have,i have 1995 f150 4.9 6 cylinder engine,and will be replacing my iat soon as i get it.mine is on the lower intake manifold towards the front of the vehicle.so i assume yours should be on the manifold somewhere.look along and behind the fuel rails.
On top of the engine, under the battery. You need to remove the battery and battery tray to get to it.
You need to replace an engine for a Ford F250 Triton 10 2005 for about $3000.
booster has nothing to do with starter. but you might try boosting battery with jumper cables . if this works it means the battery does not have enuff cranking amps when engine is hot, and you would need to replace battery