According to the 1997 Mercury Cougar Owner Guide :
Each remote takes ( 2 ) coin type , 3 volt lithium batteries
( # 2016 )
Had the same problem. You can reset it by unlocking either door with the key.
Remotes for automobiles can stop working for a variety of reasons. First check the battery, then reprogram if this is not the answer. Check with a mercury dealership to have the remote evaluated.
it might need a new battery, that happened with mine.
I had the same problem... I had to replace the battery in my remote at the dealer... hope this helps
Each remote takes ( 1 ) coin style battery ( CR 2032 ) or equivalent according to the owners manual
To replace the battery in your 2004 Murcery Monterey door lock remote all you have to do is hold it in your hand, take a knife and pop the back cover off pull the old battery out and put the new one in. Now enjoy locking your doors from a distance.
You do not have to reset the keyless remote after battery replacement.
all you have to do is click on the battery while it is in the remote. hope it helos you!
It is the same if you have can recharge your battery or you buy disposable, the Bluetooth remote may require a AA battery or a Lithium 3.0V coin battery. It will depend on what type of remote you have.
If the remote car starter stopped working after a new battery was installed in the remote, the remote needs to be reprogrammed. If the remote starter stopped working after a new battery was installed in the vehicle, the computer might need to be reset by disconnecting the battery for a few minutes.
I had a problem too when I removed the battery from my Mentor's remote . Do the following ,sit inside the car , remove the remote battery , wait for 1 minute , replace the remote battery when doing so you will see that the remote light is on ! If the light is not on try again ! Now press and hold the lock button on the remote until you hesar the doors lock . Your remote is now programed .
Cut open the remote with xacto knife , unsolder and replace the battery.