M12x1.25x35 CL8.8 Torque to 68 foot pounds.Source etrailer.com
to install a water pump on a Toyota tercel 1.5.
Lift vehicle high enough, remove mount bolt, crossmember bolts supporting it with jack and lower to create room for removel of mount,
The starter on a 1998 Toyota 4runner is held located on the transmission housing. The starter is held on by 2 bolts which mount it directly it the engine. Remove the two bolts to replace the starter.
A vehicle hitch is a mount on the rear of a vehicle where a trailer can be connected. When a trailer is hooked to a vehicle to be towed it is said to be "hitched" to the towing vehicle.
how to replacemotor mount toyota sienna 2004
Loosen the transmission mount retaining bolts. Loosen the back to engine retaining bolts. Jack the transmission of approximately 1 inch. Remove the transmission mount bolts. Remove the transmission mount. Reverse the process to install the new transmission mount.
Follow the UPPER Radiator hose from the radiator to the inlet port (aluminum casing with 2 mount bolts on the DRIVERS SIDE [ or rear of motor ] on a 4 cylinder engine). Remove the 2 mount bolts to remove the thermostat housing & the thermostat will be under before mentioned housing.
The belt side mount has bolts from the top along with the firewall side mount. The radiator side mount bolts are from the bottom and side. The transmission side mount bolts are all from the side. The top bolt is accessible after removing the fender liner.
Use a jack with a board on top to support the engine. Loosen the bolts for the motor mount. Raise the engine slightly then take the bolts out and remove the motor mount. Install the new mount, tighten the bolts, then remove the jack.
The bottom strut mount is connected to the frame by two retaining bolts. Remove the retaining bolts to remove the strut mount. Reverse the process to install the new strut mount.
Is it legal to keep your trailer hitch attached to your truck when your not pulling a trailer in New jersey?
Make sure to check the ball size and hitch size are the same first. Other then that yes, it just means the ball can withstand less weight then the receiver hitch.