The bleeder valve for the brakes on a 1997 Ford Ranger is located in the brake line where it meets the brake disc. The wheel will have to be removed to access the bleeder screw for drum brakes.
more than likely you have air in brake line and need to bleed brakes
There were 3 motors that available for the 1994 Ford Ranger. There was the 96 horsepower 2.3 L In-line 4 Cylinder, the 140 horsepower 3.0 L V6, and the 160 horsepower 4.0 L V6
Wikipedia has a great history of the ford ranger line.
Only your local auto parts store can give you the correct size and brake line for the type or model of vehicle you have.
The brake light fuse might keep tripping or going out on a 2001 Ford Ranger is there is a short in the line. The fault could also be with the part that tells the brake light to come on. This is located in the steering column. There is a brake light relay switch where the brake pedal is attached to the steering column.
It is important to have functioning brakes on a car. A brake line diagram for a 1994 Econoline E-350 RV can be found in its maintenance manual found at auto part stores.
The brake fluid level might be low in the brake master cylinder in your engine compartment from a leak somewhere , or maybe you have air in the brake line(s) and the brake system needs to have the air blead out
how do I bleed the clutch system in a 2004 ford ranger
on my 1994 ford ranger, i just removed the holding rings on each end of the in and out line very slowly until the pressure was released. you will get a bit of gas spray but nothing serious. hope this helps. fordman.
What is a a/cl dv on a 1992 ford ranger xlt vacuum line
Motorcraft BXT - 59 ( is Fords " top of the line " battery for a 2002 Ford Ranger )