Want this question answered?
The cable that is used to connect from the generator is based on the size in kW's of the generator and the generator's breaker size rated in amps. It usually is a flexible cab-tire 4 wire cable if the generator is a portable type. If it is a stationary generator is has to be wired with a flexible conduit so as not to transmit vibration from the generator to the conduit system.
If the load is single phase and the load requires 460 volts to operate, then two conductors will be needed and they will connect to a two pole breaker. If the load is three phase and the load requires 460 volts to operate, then three conductors will be needed and they will connected to a three pole breaker. The sizing of the wires will depend upon the current that is drawn by the loads.
The wattage of the water tank is needed to size the breaker and the wire to feed the tank.
a generator would prodution the heat to a house.
A 15 amp circuit breaker will handle this situation very well. The smallest home breaker is rated at 15 amp.
The cable that is used to connect from the generator is based on the size in kW's of the generator and the generator's breaker size rated in amps. It usually is a flexible cab-tire 4 wire cable if the generator is a portable type. If it is a stationary generator is has to be wired with a flexible conduit so as not to transmit vibration from the generator to the conduit system.
A welding generator is an electricity generator that is commonly used in places where the power needed to arc weld is not readily available. They are usually powered by gas or diesel engines and have a high, stable energy output suitable for powering a welding machine.
To supply electricity in the event that the main power supply is unavailable and electricity is needed, or when it is impossible to connect everything that needs electricity to an outlet.
The capacitors in a generator is to store energy produced. They are also needed when starting the generator as a considerable amount of extra power is needed at this time.
If the load is single phase and the load requires 460 volts to operate, then two conductors will be needed and they will connect to a two pole breaker. If the load is three phase and the load requires 460 volts to operate, then three conductors will be needed and they will connected to a three pole breaker. The sizing of the wires will depend upon the current that is drawn by the loads.
You can absollutely power your mobille kitchen with either propane gas or by using a generator. Many people have a preference on which way they like to power their mobile kitchen. It is totally up to the individual. It is likely powered by both propane for a gas-fired range top that is preferred by caterers and chefs, as well as a generator to power blenders, food processors, mixers and other appliances as needed. If the food is arriving prepped and needs only to be cooked and assembled, it is likely that propane would be the fuel source over a generator.
The wattage of the water tank is needed to size the breaker and the wire to feed the tank.
What KVA generator is needed to run 1 ton split?Read more:What_KVA_generator_is_needed_to_run_1_ton_split
A minimum of 15-amp breaker is "needed", but a 20-amp is often required by electrical code for that situation.
The generator should be about ¾ hp.
100
The voltage of the generator needs to be stated to give an answer.