16 AWG is plenty large enough for a 50 or 100 watt lamp.
Yes, the ballast is an intricate part of the fixture that the lamp screws into regardless of what size wattage the lamp is.
LEDs and CFLs use about a quarter of a halogen so the answer is 35-40 watts.
No, it is not recommended to use a 70 watt metal halide lamp with a 150 watt ballast. The lamp and ballast wattage should match to ensure proper operation and to prevent damage to the lamp or ballast. It is best to use a compatible lamp and ballast with matching wattages.
6 watt bulb for mini lamp
No, you cannot use a 1000 watt HPS (high-pressure sodium) lamp without a ballast. The ballast is essential for regulating the electrical current flowing through the lamp, which is necessary for it to operate properly and prevent damage. Trying to operate a 1000 watt HPS lamp without a ballast can result in the lamp not lighting up or malfunctioning.
It depends on the size of the lava lamp
If the exit fixture uses a LED lamp it will have a 1 to 3 watt rating. If it is a incandescent bulb, each lamp will draw about 25 watts each.
Yes, you CAN. The real question is whether or not you should. There is always a fire hazard, especially if the lamp is near drapes, or has a large shade or whatnot on it. If it was me I'd only use a 60 watt bulb in a 60 watt lamp.
no , it will burn out
Yes, you can use a 32 watt T12 fluorescent lamp in a fixture that previously housed a 40 watt T12 fluorescent lamp. However, the light output will be slightly lower. It's advisable to check the fixture's compatibility with the lower wattage lamp to ensure proper performance.
If the socket threads of the lamp are the same then yes the bulbs can be interchanged. The 5 watt bulb will glow brighter than the 4 watt bulb. If by a 4 watt light you mean a 4 watt fixture, then it is not recommended to place a larger wattage lamp in a fixture that is rated by the manufacturer at a specific operating wattage
For a 100 watt 12 volt lamp, you should use a wire gauge size of at least 18 AWG to ensure it can handle the current without overheating. It's always best to refer to the manufacturer's recommendations for the specific lamp you are using.