0
What size globe do i put into a internal rear brake light for a Mitsubishi 1994 sedan?
Wiki User
∙ 8y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why does parking brake light stay lit on 1999 Mitsubishi Montero sport?
The parking brake light stay lit on the 1999 Mitsubishi Montero sport the parking brake is working and you have not put the light off.
What is the difference between the tail light and brake light?
In some (but not all) vehicles, the tail and brake light are part of one globe, generally, a 12v 21/5W globe. The tail light comes on when the parklights and/or headlights are on, and the brake light will come on when the foot is applied to the brake pedal. The one globe has 2 filaments and the pin for the globe is offset (the base also has 2 x contacts). On vehicles such as trailers, the brake and tail globes are generally separate (2 x festoon globes) each with differing wattages. Hope that helps! Lindalegend from Tassie.
What could be the problem if both brake lights do not work but the middle brake light does when the fuse and bulbs are fine on the 2002 Daewoo Matiz?
You've probably put the globes in backwards. The brake light globes also contain park light filaments. So if you don't correctly fit the globe into the holder only one of the two internal light circuits operate -twice :P
What does the brake light mean on a 1997 Mitsubishi diamante?
either you have a blown bulb, low brake fluid or you need new brake pads
Why do the brake light and the battery light come on at the same time on your Mitsubishi motero 2000?
its telling you your alt is going out
Why is a 2000 Mitsubishi truck lights work fine however the brake light does not light up when you push on the brake The fuse looks fine and the bulbs are good What else should I consider looking at?
. your question about the brake light. the brake light shown not light up went you press on the brake pedal. if it light up is went you have a brake problem. good look
Why would the emergency brake light stay on when the emergency brake is off in a 92 Mitsubishi Eclipse?
If the light stays on when the emergency brake is not engaged, this indicates the brakes are getting low and need to be replaced.
How do you change the rear right brake light bulb on a Mitsubishi eclipse 2001?
If you want to change the light you have to remove the right rear internal panel (located in the trunk). Only after removing the panel you will gain access to the light. Then it's just matter of removing nuts replacing the light and putting everything together.
How do you replace third brake light on a 2006 Mitsubishi eclipse?
You have to remove the interior trim of the lift gate.
Where is the relays or flasher switch for the turn signal and brake lights on a 1995 Mitsubishi Montero?
The 1995 Mitsubishi flasher relay switch and the brake light relay switch can be found beneath the dashboard. Both switches will be on the drivers side of the dashboard, near the brake pedal.
How do you repair a tail light of a Mitsubishi eclipse 1996 that is not working when you turn on the headlight but works when you brake?
Replace the bulb it works when you turn on the driving lights and when you brake. there are two little springs inside the light one is for the brake light and the other is for the driving light. All you need to do is replace the bulb. good luck.
How do you turn off your 1994 Mitsubishi Mirage brake light?
TAKE YOUR FOOT OFF THE BRAKE!!! If your brake fluid is low the brake light will be on, there is a float inside the brake fluid reservoir, after you fill it up, if the light is still on take the cap bake off of the reservoir and make sure that the float is floating, if it isn't wiggle it around with your finger and it should pop to the top.
