Want this question answered?
The primary sprocket nut is 1 - 1/8 inch.
The front compression nut is right handed, however the nut hold the clutch hub is left handed.
Press down the rear foot brake and use a breaker bar or large ratchet with correct size socket to loosen nut on front sprocket. (never use impact wrench NEVER EVER!)Once you get the nut broken loose. Unclip your chain and put the gear in neutral and pull the chain through and set it aside. Put clutch in first gear and continue to ratchet loose the nut. Loosen nut all the way. Change out the sprocket. Tighten nut as much as you can with bike in gear. Put your bike back in neutral and feed your chain around the sprocket pulling it through and resting both sides of it on the rear sprocket where you will reclip the master link. Meeting both sides of the chain on the rear sprocket will make it easy to clip as the rear sprocket holds your chain for you. Once master link in chain is clipped. Step on the rear brake and crank down to spec lbs on the front sprocket bolt. If you don't know the foot lbs.. just make sure its real tight. Your done!
what size is the front axle nut on 2008 nissan altima.
what size is the nut holding the front hub on a 2001 ford escape
It is a 36mm nut/socket.
The front axle nut would be a 35mm.
Front axle nut is 35mm
What size is the nut on the front break system to take the rotor off. Of my 2002 Trailblazier LT 4.2l 4x4.
what size socket for front axle nut 1991 ford tempo
The axle shaft nut is 32 mm.
Front axle nut should be a 35mm.