0
What size nut on the bolt that holds the blades on a la105 john deere riding lawnmower?
Wiki User
∙ 9y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What holds a helicopters blades on?
The rotor hub holds blades on
What is the oil capacity for John Deere 1949 model A?
A John Deere model A holds 9.25 qts of oil.
What part of a scissor is the fulcrum?
The fulcrum of scissors is the pin or screw which holds the two blades together.
Bull riding harness?
There is no "Bull Riding Harness" It is a bull rope that goes around the front of the bulls stomach and the bull rider holds onto.
How is a pony guided?
The bridle has reins for riding horses and the person holds onto them and steer it where it needs to go.
How does scissors levers and screw are related?
A scissors actually acts as two levers, since it has two blades that act jointly. The two blades are connected by a bolt or screw of some sort, and that acts as the fulcrum for both blades. The motion of the handle pivots on the fulcrum and is then transmitted to the other end, with the sharp edges.
What is a Jesus Nut?
it is a nut that holds the main rotor to the mast of some helicopters. The Jesus Nut is the large nut on the top of the mast that holds the entire rotor blades and rotor mechanism to the mast. Bascially, it holds the weight of the aircraft by the top of the mast and if it should fail, then all you can do is say "Jesus!".
The Basic Parts of a Power Lawnmower?
A power lawnmower is very much like a miniature car. It has an engine, a gas tank and cap, a spark plug, a governor, a muffler and an air cleaner. The wheels even have hubcaps. The lawnmower has an upper handle and a lower handle, and handle knobs to adjust the length of the handle. At the base of the handle is the drag shield. The housing or the deck holds the blade. The engine sits on top of the housing and is started by the starter handle. The lawn mower also has a toe guard and a discharge chute that shoots the grass clippings either onto the lawn or into a grass catcher. Lawnmower parts can be found at a hardware or home furnishings store.
What is the average amount of wood I will need to build a shed that holds a lawnmower?
A typical shed will need at least twenty 2x4's as well as some crossbeams and 1/2" or 5/8" drywall. anonymous@oola.com
How much oil yfz 450?
there are 2 separate oil galleries the crankcase holds half a quart. i change mine every 15 hours of riding. the transmission holds about 3/4 of a quart and i change that every 3rd oil change
Where do you check the hydraulic oil level on a john deere skidsteer 6675?
You remove the right side panel and observe the hydraulic reservoir. Fill to the line IT HOLDS 6 GALLONS 10-30 WT OIL
How much hydraulic fluid does a john deere model 2555 tractor take?
A 2155 w/o 4wd holds 50 qts of hydraulic fluid. A 4wd takes 53.2 qts.
