Want this question answered?
you will need a 14mm socket for the drain plug & a special oil fliter cup socket for the oil fliter. the oil filter cup socket is available from most auto parts stores or your local Toyta dealership.
The automatic transmission drain plug for most Toyota vehicles is a 10x1.5 thread size, with a head (hex) size of 14mm. You can use a 14mm open end wrench, or a 14mm hex socket, whichever is easier.
14mm
Its a 10mm Allen Key.
It's in metric: 14mm.
You can use a 11 centimeter socket to remove the transmission drain plug. The socket should be a five-point socket.
a 3/8 ratchet w/ no socket, its on the bottom of tranny and refill on top of tranny w/ 17mm socket on the bolt that has ATF stamped in it.
Remove hose from bottom of radiator and let it drain into a container.
There is a good chance that it takes a standard size socket rather than a metric socket, it was like this on my Toyota Celica. 17mm
The tools needed for an oil change tend to be common tools. A floor jack is needed to access the oil pan. A pan which is used to drain oil into. A wrench and socket set is used to remove and replace the oil cap.
drain fluid, then remove hoses and unscrew four screws.
The oil drain plug on the sump is to the rear of the sump on the side 17mm spanner or socket required to remove Drain plug