That would depend on the pressure huh?
Under 400 GPM at best (without friction)
First you need the size of the pipe and the volume of water supply. Pressure will vary during usage. Standard well system operates between 20-40 psi and city systems operate from 50-70 psi.
Nothing as long as the pressure pipe is not used for potable water as you cannot make a direct connection and depending on the GPM flow what size the larger sewer pipe is as 1 GPM (pumping) is considered 1 fixture unit when sizing the drainage system ALSO make sure the pumps system enters at a right angle 45 deg so your not eroding the side of the larger pipe out
1/2" water lines. Drain line determined by flow rate of showerheads and bodysprays being used. 5.7 gpm or less flow rate would need 1 1/2" drain, which is minimum size allowed.
gallon per minute (gpm).
Under 400 GPM at best (without friction)
-39
Before you can calculate the flow, you must also have the pipe size and its coefficient of friction.
First you need the size of the pipe and the volume of water supply. Pressure will vary during usage. Standard well system operates between 20-40 psi and city systems operate from 50-70 psi.
100
7.359
Nothing as long as the pressure pipe is not used for potable water as you cannot make a direct connection and depending on the GPM flow what size the larger sewer pipe is as 1 GPM (pumping) is considered 1 fixture unit when sizing the drainage system ALSO make sure the pumps system enters at a right angle 45 deg so your not eroding the side of the larger pipe out
19 gallons
Yes, easily.
80 gpm
If 27 means 27' in diameter, sure, why not?
A pipe that is 10 inch would have the velocity of 2.75 feet. This is 2.75 feet with 722 GPM.