Size: M6 (metric)
Length: 10mm
Drive Style: hex socket
http://www.Amazon.com/s?ie=UTF8&rh=n%3A16410591%2Cp_11%3AM6%2Cp_measurement_system%3AMetric&page=1
What size bolt for a 2005 Honda civic DX power steering tank bracket..
theres no point in putting this question on wiki answers just ask the person at the garage
My Honda civic 2002 shakes fora few seconds as I turn the engine off.It happened right after replacing the engine mount on the driver's side.
The backseat is held on by mounting bolts. Removing the bolts will allow the backseat to pop off of the 1999 Honda Civic. Installation requires to mount the seats correctly.
The size of the screw needed to mount a license plate on a 1998 Cadillac STS is 1/4-inch?æby 1/2-inch. They make license plate kits that includes all needed hardware.
Not much at all. Be careful which place you go to. Some places love to use genuine Honda parts which is NOT needed for a support (unless it's an engine mount), just use a piece of metal and make your own support for CHEAP!
I think 5mm X 20mm.
Sounds like you may have a broken motor mount that is causing a line to crimp or somethig.
Yes it has been done. You need the right engine mount, wiring, fabrication, ect.
it is next to where to mount the oil filter. it is either 17mm or 19mm with 58 lb torque
An air conditioning belt on a 2000 Honda Civic is adjusted with a pulley. The loosen the adjustment pulley to create enough and pull the belt off. Remove the torque mount bolts to allow enough room to slip out the old belt and install the new belt.
You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.