34 mm
30
36 mm
once you remove the retaining tabs off of the washer that are covering the nuts, it takes a 34MM DEEP SOCKET
http://www.ctatools.com/catalogs/Axle_Nut_Application_Chart.PDF has a handy size chart CcRider
this should be easy to find but it isn't don't know why ! people that right on forums are to stupid to include ........ " remove the axle nut" correction = remove the axle nut using a 29mm socket! how hard was that !!!!!!! 29mm is what you need for that nut !
I just did mine. It required a 33mm socket.Put a screwdriver through the hole in the caliper and into the cooling veins in the brake disk to prevent it from turning while loosening/tightening the axle nut.
It is a 36 MM socket
hey i think its a 35mm socket
it is a 2001 Pontiac Montana that has broken three bealts so far I need to know what pully I will need to replace?
30mm
Just did mine, 33mil deep well socket will do the trick.
35 mm