0
What size socket is needed to change spark plugs on 1987 Chrysler lebaron?
Wiki User
∙ 14y ago
13/16 inch
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What size socket do you need to change plugs in a 1994 Chrysler lebaron with a v6?
13/1613/16
What size is the hub nut on a 1994 Chrysler lebaron?
It takes a 1 1/4 inch socket
How do you change the neutral safety switch in a 1991 Chrysler lebaron?
First unplug the wire harness from the switch. Using the correct size socket (1" if I remember correctly) remove the switch counterclockwise from the transmission. Install the new one in reverse order.
What socket is needed for the front axle nut of hub on a 1998 Chrysler Concorde?
34 mm metric socket. They cost under teen bucks
What is the socket size needed to remove the drive axles on a 1997 Chrysler lhs?
1 5/16 in
What kind of socket is needed to change the oxygen sensor on 97 dodge caravan?
It is called an oxygen sensor socket.
What socket is needed for the front axle nut for the hub assembly on a 1994 Chrysler Concorde?
inch and a quarter or one and five sixteenths
What size socket is needed to change spark plugs in 5.4liter engine?
youll need a 5/8 superdeep plug socket
What tools are needed to change the pads on a 1994 Eclipse?
socket rench and a c-clamp
What tools are needed to change brake pads on a 1998 Chevy Monte Carlo?
ratchet or socket
How do you change front turn signal light bulbs on 2000 Chrysler Concorde?
Reach in from the bottom of the fascia. The socket takes about a quarter turn.
Where is the oxygen sensor located on 1995 Chrysler LeBaron?
The 1995 Lebaron came with the 3.0L V6 engine only. The oxygen sensor is behind and below the engine low to the firewall. Removal of the air filter box is necessary to access the sensor. A specific O-sensor socket with a slit in the side is used to install the sensor without damaging the wires. If you are not keeping the old O-sensor wires intact then use a regular deep-set 7/8in socket to remove the sensor if the slit-socket spreads to much to remove it. Just cut the wires off so the regular socket fits over the sensor. Fun, Huh?
