Want this question answered?
No.
Remove the drive belts, crankshaft pulley, and timing covers. Align the timing marks on the camshaft and crankshaft and r+r the belt
Take off belt, remove bolt in center of pulley, replace with new pulley (comes with bearing). Reverse to install Take off belt, remove bolt in center of pulley, replace with new pulley (comes with bearing).
Not possible. You have to remove the whole light assembly.
You remove the ac compressor and install a pulley bypass kit from a part store.You remove the ac compressor and install a pulley bypass kit from a part store.
Rear wheel drive with option of either four wheel drive or all wheel drive.
Loosen bolt in tension pulley, then loosen tension bolt. Replace belt. Tighten tension bolt. Last, tighten bolt through pulley.
Inside the engine. It is the part that spins and has the pistons attached to it. The flywheel bolts to it on one and and the front pulley drives the belt.
Loosen the tensioner pulley. The tensioner pulley will slide to the right. This will loosen the alternator belt. So it can be removed.
In order to remove the water pump on a 2000 Mazda Millennia, you must first remove the timing belt and the pulley for the water pump. Remove the pump itself by detaching the four bolts that are securing it. Next, replace any gaskets, install the new pump, then the pulley, and then the timing belt.
I'm trying to replace the headlight assembly for a 2000 Jeep Grand Cherokee Lerado. What bolts or screws do I remove
There are about three or four screws around your alternator that u will have to remove, once you do it, you will have to pull on the lower left pulley to remove it, when putting the new alternator in you pull on the same pulley and put the screws back in place