It takes a standard Zerk fitting. If your having trouble with the Alemite fitting on the end of the grease gun, it may be worn out or just loose.
There aren't any.
If the u-joint has never been changed you can't grease them because factory u-joints don't have grease alimites...you will have to change the u-joint. After market u-joints have alimites.
http://wiki.answers.com/Q/Where_are_the_grease_fittings_located_on_a_2002_Chevy_Silverado_2500 has already answered this question
There are no u-joints on the venture van. It has CV joints that are sealed with rubber boots and cannot be serviced. They can only be removed and rebuilt or replaced, etc
there are no grease fittings on the newer cars, all ball joints and steering parts are permanitly sealed.
There are 3 grease fittings on a 2002 dodge 2500. Once the aftermarket joints are installed the number increases depending on the joints installed.
how do i change the spark plugs on a Chevy silverado 1500
The joints from the factory are sealed and can not be greased. After market replacements may have a zerk and be greaseable.The joints from the factory are sealed and can not be greased. After market replacements may have a zerk and be greaseable.
picture of location of the fuel filter on a 2002 Chevy silverado 1500 LS.
tie rods may be ball joints that is all
The front drive shaft did not have any grease zerks from the factory.
What's the curb weight of 2002 Chevy Silverado 1500 LT , Z-71