answersLogoWhite

0


Best Answer

A ton of A/C is 844.2 watts, so 5 tons is 4222.5 watts. Design extra 10 percent for constant load for total of 4650 W. Using 240 volts at 20 amps (W = Amps x volts), on 12 AWG wire, you would get 155 feet before having a 5% voltage drop. If inrush current is 30 amps at startup, you would have 7.5 percent drop in the cable during startup. To be safe, perhaps bump up a size (10 AWG) and have 4.7 percent drop during inrush (at 155 ft), or be able to run up to 170 feet at 30A load with 5 percent drop. In any case, because normal operating current is 20 A, you should use a 30 A breaker and thus 10 AWG wire, to be on safe side. If the unit is 120 V, the distances are halved for the same amount of drop.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar
More answers
User Avatar

Anonymous

Lvl 1
3y ago

#12 gage

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What size wire do you run for a 5 ton outdoor air cooled condensor unit?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Condensor or condenser which is the correct one to use regarding the outdoor unit for an air conditioning system?

CondenSER is correct. CondenSOR is not a real word. Regards!


HVAC problem an outside condensor model 38ycc042300 paired with FAYANf048 freon the filters are clean repair is stumped as to why it is not working?

The indoor unit is bigger than the outdoor unit


What causes the outdoor AC unit to cycle on and off when the sun is shining right on it?

The thermostat(s) in your house cause (control) the unit you are referring to. It is actually called the condensor and is the part that expels the heat from inside your house to the outside.


What is the tonnage on model 10ajb48a01 condensor ac unit?

4tons


Is there any ac unit that use water?

Most all large chillers are water cooled. due to the increased efficiency, ease of maintenance and outdoor space savings.


What temp should home or office air conditioning cool to?

It depends on several factors. Outside tempature, unit size,cooled space, insulation values etc. In my area during peak outdoor tempatures of 100-102F, 72-75F is optimal but expensive.


Why is it important to have drainage for outdoor unit on a heat pump?

why is it important to have drainage for the outdoor unit


Why is it important to have drainage for outdoor unit on heat pump?

why is it important to have drainage for the outdoor unit


What ton is a goodman clt48-1B condensor?

It is a 4 ton Condensing Unit


Can you mix a heat pump condensor unit with a non heat pump indoor unit?

Check with the manufacturer to see if they are compatible.


What size wire is used for 18000 dual zone senville mini split?

You can use #10 or #12 THHN stranded wire with a 20 amp breaker for the outdoor unit. A disconnect is required within sight of the outdoor unit. The wire between the outdoor and indoor unit should be 14/3 with ground or 14/4 stranded. Do not use solid or aluminum wire for either application.


How does a home ac unit work?

Refrigerant is pumped by a compressor located in the out door section called the condensor to a evaporator coil as a liquid through a metering device.Your air handler or furnace blows air from your home across the evaporator where the liquid refrigerant expands into a gas and picks up the heat from the air across the coil.Then the gas is pumped to the condensor and is again condensed into a liquid through the means of cooling the gas usually by a fan pulling air across the coils of the outdoor unit.