inch wide adjustable wrench
== == REPLACE ONLY WITH FLEXPIPE - MUST BE WELDED IN - USUALLY AROUND $100-150 AT A MUFFLER SHOP.
Look between exhaust pipe & block.
In the exhaust pipe, near the engine.In the exhaust pipe, near the engine.
If you can grab it with a pair of vice grips or even a pipe wrench and get it out then you could replace it. If that will not work you will have to buy an easy out and use that to remove the stud.
It is basically the same as a regular pipe wrench except on the inside. It is sized for the pipe and has a toothed section that grabs when it is turned. You turn it with a wrench or socket. They will not take as much strain as a regular pipe wrench.
oxygen sensor on 2.0 is located on the exhaust pipe on v6 it is located in front and rear exhaust manifolds
Unplug it at the wiring connector, and then get a wrench that fits it and screew it out of the exhaust pipe.
i think Ridgid 31005 8" Straight Pipe Wrench is best.
A pipe wrench, or an adjustable wrench, is used for any job which requires being able to adjust the wrench after inserting it into a tight or confined space, such as when attaching pieces of pipe together near a wall.
A wrench normally has a fixed size head. A pipe wrench has an expanding jaw and can fit a variety of sized pipes.
Chances are if you put a Pipe Wrench on the Pipe and turn it, you will damage the fitting that the Pipe screws into below ground. You should dig it up and use two Pipe Wrenches.
is gripping a pipe with a stillson wrench an andvantage or a disadvantage of friction?