A 10mm wrench, or if you don't have metric wrenches, a 13/32 wrench.
usually a size 13 metric
m8-1.0x 20mm I just replaced mine, it was the top bolt
my m8's dad has size 16 feet (huge feet but smelly)
Depending on the model, the rotor may not contain a jackscrew hole. For ones that do, they're usually the same thread size as the caliper to bracket bolt (M8-1.0).
M8, which actually starts about 10 miles west of Glasgow.
These are standard metric screw/bolt sizes. You should be able to find them at a local Hardware Store. Such hardware is also available online.
me m8 so thats canni cush m8
M8 paper is used to detect chemical changes. Steps for passively using m8 paper are, remove a half sheet, dip the paper, observe the m8 paper, compare any color change, report results and discard m8 paper.
Torque depends on the size of the bolt as you have already specified grade 8.8. Here are some recommended settings: M8 (13mm across the flat head) 25Nm M10 (17mm across the flat head) 49Nm M16 (24mm across the flat head) 210Nm
dipping a sheet of M8 paper into the liquid
Identify three characterristics of m8 paper?
Dipping a sheet of M8 paper into the liquid
dipping a sheet of m8 paper into the liquid