answersLogoWhite

0

To mount your TV, use M8 size bolts.

User Avatar

AnswerBot

4mo ago

What else can I help you with?

Related Questions

What size bolts should I use for a TV mount installation?

For a TV mount installation, it is recommended to use M8 size bolts.


What size lag bolts should I use for a TV mount installation?

For a TV mount installation, it is recommended to use lag bolts that are at least 2.5 inches in length and have a diameter of 1/4 inch. These bolts should be able to securely hold the weight of the TV and mount on the wall.


What size and type of lag bolts should I use for securing a TV mount to the wall?

For securing a TV mount to the wall, use lag bolts that are 2.5 inches long and 1/4 inch in diameter. Make sure they are suitable for the type of wall material you are mounting the TV on, such as drywall or concrete.


What size screw should I use for a camera mount?

For a camera mount, you should use a screw size that matches the thread size of the camera mount. Common sizes for camera mounts are 1/4-20 and 3/8-16, which refer to the diameter and thread pitch of the screw. Make sure to check the specifications of your camera mount to determine the correct screw size to use.


What bolt size to mount transmission to a Ls motor?

If you don't have the original bolts to see what size they are then you will have to just look at the bolt holes and see the size. Use a bolt and try screwing it into the hole.It should fit snuggly and no play side to side.Length will have to be trial and error.They should go all the way into the hole with at least 8 full turns.And they must clamp up tight. Use only grade 8 bolts.


What size tv should you use a wall mount for?

Any Size, different wall mounts are for different size t.v.s


What is the recommended size and type of bolts, such as m4 bolts, to use for assembling the components of this project?

For assembling the components of this project, it is recommended to use M4 bolts. These bolts are of the appropriate size and type for the task.


What size torx bolts rear shocks corsa d?

The rear shocks on a Corsa D typically use Torx bolts, specifically T40 size for the upper shock mount. For the lower mount, you may find T30 or T40 bolts depending on the specific shock absorber design. Always verify the exact specifications for your vehicle model and year before proceeding with any repairs.


How do you replace 1991 astro van motor mount?

Use a jack with a board on top to support the engine. Loosen the bolts for the motor mount. Raise the engine slightly then take the bolts out and remove the motor mount. Install the new mount, tighten the bolts, then remove the jack.


What nut size is used to mount the downstream oxygen sensor in a 1998 rav4?

Most modern Toyotas use a M8x1.0 nut for the O2 sensor flange bolts.


What size Allen do you use to take caliper bolts off 07' grand caravan?

Should be 6 or 7 mm.


How can I securely mount a heavy object to concrete?

To securely mount a heavy object to concrete, you can use anchor bolts or concrete screws. First, drill holes into the concrete using a hammer drill. Then, insert the anchor bolts or screws into the holes and tighten them securely with a wrench or screwdriver. Make sure to use the appropriate size and type of fastener for the weight of the object.